Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Epson 9600 printsize help please  (Read 1805 times)
patrick bellett
Newbie
*
Offline Offline

Posts: 4


WWW
« on: April 29, 2006, 05:21:09 PM »
ReplyReply

i am trying to print a 44x50 inch image onto 44 inch paper ( premium Lustre photopaper ) & despite setting the page set up to 44x50inch etc etc... all that will print out is a small part of the image ( 30x45cm!! ) I am running OSX10.4.6 & CS2. can any one help?

I m also keen to hear from anyone who can explain the difference between banner no margins & normal print modes? I am getting some of my image cut off when using no borders mode..

Cheers patrick
Logged
p.tinson
Jr. Member
**
Offline Offline

Posts: 58


« Reply #1 on: April 29, 2006, 06:50:07 PM »
ReplyReply

Patrick
     The problem you are having is that the custom pape size you are setting up is in one of the directions above the maximum paper size for the printer (OSX will alow you to do this without any warnings). Posibly you are putting the width as 50 inches?
When printing with the borderless printers there are normally two options, borderless retain size and borderless auto-expand, with borderless auto-expand the image will be expanded by 1/4" this is to ensure that the printer will print over the edge of the paper and not leave a white border even if the paper skews slightly as its feed through the printer. With retain size you need to ensure that your image is slightly oversize for the above reason.
The banner mode is there to enable long prints to be made from applications that support tileing such as Illustrator where the image is tiled into pages and with the save roll paper checked in the roll paper options the pages will be printed without any visible breaks.

Peter
Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad