Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Moab Entrada Surface difference  (Read 3132 times)
chriscor
Newbie
*
Offline Offline

Posts: 38


« on: July 31, 2006, 03:56:30 PM »
ReplyReply

Anybody here using Moab Entrada paper notice a difference in the texture of the surface between the 300 and 190 weight paper?
I just switched from printing on UltraSmooth to Moab because I needed a paper with a whiter base.  I proofed my images on the 190 weight Moab paper and I'm printing the finals on the 300 weight paper.  There's a noticeable difference in the surface smoothness of the two papers.  Has anyone else experienced this?

Thanks
Chris
Logged
chriscor
Newbie
*
Offline Offline

Posts: 38


« Reply #1 on: August 01, 2006, 05:56:19 PM »
ReplyReply

The answer is yes.  I just spoke with someone at Moab and they confirmed that there is a surface difference between the papers.  Apparently  thicker papers have a rougher texture.   On the images I'm printing it takes on the appearance of increased film grain.
Logged
JeffKohn
Sr. Member
****
Offline Offline

Posts: 1671



WWW
« Reply #2 on: August 02, 2006, 12:21:57 AM »
ReplyReply

Your post prompted me to perform a similar comparision with Hahnemuhle Photo Rag, I which I just recently bought 13x19 in 308gsm and 8.5x11 in the lighter weight. Same thing, the thicker paper has a bit more texture. I don't find it objectionable, though, in fact I prefer the texture of the heavier paper.
Logged

esantos
Newbie
*
Offline Offline

Posts: 9


« Reply #3 on: August 02, 2006, 11:12:22 AM »
ReplyReply

Not to steer off topic but has anyone experienced surface flaking with Entrada? I tried a few sample sheets about two years ago and I decided not to buy this paper because it would flake quite a bit. I have never had this problem with Ultrasmooth and have been using it since. Has this been corrected by Moab?
Logged
StephenS
Newbie
*
Offline Offline

Posts: 29



« Reply #4 on: August 02, 2006, 11:51:31 AM »
ReplyReply

yes, a fair degree of surface flaking if you don't brush the surface prior to printing. I haven't checked some older prints yet to see if the surface has flaked any more  but I will at my first opportunity.
Logged
abiggs
Sr. Member
****
Offline Offline

Posts: 544



WWW
« Reply #5 on: August 02, 2006, 12:29:36 PM »
ReplyReply

Quote
yes, a fair degree of surface flaking if you don't brush the surface prior to printing. I haven't checked some older prints yet to see if the surface has flaked any more  but I will at my first opportunity.
[a href=\"index.php?act=findpost&pid=72405\"][{POST_SNAPBACK}][/a]

All fine art matte papers need to be brushed prior to use............
Logged

Andy Biggs
http://www.andybiggs.com
Africa Photo Safaris | Workshops | Fine Art Prints
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad