Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Saving paper on 9800  (Read 2088 times)
jensenfish
Newbie
*
Offline Offline

Posts: 7


« on: October 26, 2006, 05:20:30 PM »
ReplyReply

When I insert a new roll of paper almost a foot of it is wasted before the printing begins.  Any suggestions out there on getting by this?
Thanks,
Jensen
Logged
Brian Gilkes
Sr. Member
****
Offline Offline

Posts: 431


WWW
« Reply #1 on: October 27, 2006, 04:34:22 PM »
ReplyReply

That certainly does not happen with my 9800. The lead is a few cm. Your situation should be checked out. Maybe if you detail your workflow one of us may be able to spot something. Does it happen all the time and with different paper size settings? Sometimes it is worthwhile to reload latest drivers and firmware from Epson (USA). You may have a corruption somewhere.
HTH
Brian
www.pharoseditions.com.au
Logged
Marty C
Jr. Member
**
Offline Offline

Posts: 65


WWW
« Reply #2 on: October 27, 2006, 07:37:05 PM »
ReplyReply

When using roll stock, switch the paper type on the control panel to sheet and then lock the lever down and let it initialize. Then switch it back to roll media. The printer will start printing with minimal loss of media.
« Last Edit: October 28, 2006, 05:55:44 AM by Marty C » Logged
jensenfish
Newbie
*
Offline Offline

Posts: 7


« Reply #3 on: November 08, 2006, 08:05:44 AM »
ReplyReply

Quote
When using roll stock, switch the paper type on the control panel to sheet and then lock the lever down and let it initialize. Then switch it back to roll media. The printer will start printing with minimal loss of media.
[a href=\"index.php?act=findpost&pid=82609\"][{POST_SNAPBACK}][/a]



THANK YOU MARTY.  That did the trick.  I thought there should be a simple solution.
Many thanks...
Logged
jecxz
Sr. Member
****
Offline Offline

Posts: 377


WWW
« Reply #4 on: November 08, 2006, 12:47:25 PM »
ReplyReply

I had this problem too on my 9800 when I switched to either Fine Art or the Velvet roll paper, (I switched to roll wo/cutter at the same time) and it ejected quite a bit when loading a roll.

Yesterday I put a roll of Enhanced Matte in and switched to roll w/cutter (same time) and it didn't eject any extra and was fine.

Could this be the same problem?
Logged

Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad