Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Getting Rid of wheel marks  (Read 1824 times)
mr.dude
Jr. Member
**
Offline Offline

Posts: 57


« on: November 12, 2006, 06:24:00 AM »
ReplyReply

Hi,
 
   i'm getting those little trails of dots running across my prints from the IPF5000 on hahnemuhle fine art pearl.  anyone know how to get rid of the problem?  thanks
Logged
marcmccalmont
Sr. Member
****
Offline Offline

Posts: 1724



« Reply #1 on: November 12, 2006, 02:47:06 PM »
ReplyReply

I got the same with Red River silver paper and have not yet figured out how to correct it, any advice would be appreciated. I might try increasing the time between passes
Marc
« Last Edit: November 12, 2006, 02:48:40 PM by marcmccalmont » Logged

Marc McCalmont
mr.dude
Jr. Member
**
Offline Offline

Posts: 57


« Reply #2 on: November 13, 2006, 03:49:32 AM »
ReplyReply

well i had some time to use the printer more today.  on the printer's front panel, i went to the media settings, selected the paper setting i was using for FAP, increased the head height to highest (high didn't work), and set the vacuum to "strong".  the wheel marks an other scratches are gone.  not sure if the vacuum strength made any difference but i'll figure that out later.  staying up and figuring out the printer means not get much sleep though
« Last Edit: November 13, 2006, 03:50:58 AM by mr.dude » Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad