Ad
Ad
Ad
Pages: « 1 2 [3]   Bottom of Page
Print
Author Topic: Any new 17" printer rumours?  (Read 20525 times)
Dale_Cotton
Sr. Member
****
Offline Offline

Posts: 580


WWW
« Reply #40 on: February 25, 2008, 08:51:15 AM »
ReplyReply

Phil Brown wrote:
Quote
If you have carts showing as low (giving a low warning) and you get banding and see losses in the nozzle checks and can't revover with a clean, I'd suggest changing the carts showing as low as they may be running out. You should see that before you run so dry as to be any real problem.
Thanks! I had been planning simply to replace carts from the initial set as they dropped down to may the 1/8th level. Good to know I can push a little further.
Logged
Farmer
Sr. Member
****
Offline Offline

Posts: 1631


WWW
« Reply #41 on: February 25, 2008, 02:46:13 PM »
ReplyReply

Quote
Phil Brown wrote:

Thanks! I had been planning simply to replace carts from the initial set as they dropped down to may the 1/8th level. Good to know I can push a little further.
[a href=\"index.php?act=findpost&pid=177219\"][{POST_SNAPBACK}][/a]

Under normal circumstances, of course, you wait until they say they're empty but I reckon you were on the right track to be wary of them this time around due to the interupted initialisation.
Logged

Pages: « 1 2 [3]   Top of Page
Print
Jump to:  

Ad
Ad
Ad