Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Tethered capturing from Phocus with 132c and AFD  (Read 1634 times)
A.K.
Jr. Member
**
Offline Offline

Posts: 83



WWW
« on: October 30, 2008, 02:30:56 PM »
ReplyReply

Hello,
Is there a way to perform a remote capture from Phocus using 132C back and a Mamiya 645AFD body? The camera seems to be not recognized by the software: the back fires but the image is certainly black. In FlexColor the function works correctly the camera also fires when the capture is performed.    
Looking forward to getting any advice.
Logged

Regards,

Andrey Kulpin
www.andreykulpin.com
VanKou
Newbie
*
Offline Offline

Posts: 46


WWW
« Reply #1 on: October 30, 2008, 03:14:28 PM »
ReplyReply

Isn't this one of the older backs?  i was told that these older type backs (I have a V96C) are not supported by phocus as far as tethered capture goes...Check with Hasselblad again, yours might be a different story.
Logged

Nick-T
Sr. Member
****
Offline Offline

Posts: 462


« Reply #2 on: October 30, 2008, 03:47:04 PM »
ReplyReply

Quote from: VanKou
Isn't this one of the older backs?  i was told that these older type backs (I have a V96C) are not supported by phocus as far as tethered capture goes...Check with Hasselblad again, yours might be a different story.
Not so, I Have a 384 (on an H2) working just fine with Phocus, not sure what the issue could be with the AFD.

Nick-T
Logged

Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad