Ad
Ad
Ad
Pages: « 1 [2]   Bottom of Page
Print
Author Topic: a second monitor for tools  (Read 5396 times)
erick.boileau
Sr. Member
****
Offline Offline

Posts: 469


WWW
« Reply #20 on: October 06, 2009, 04:59:21 PM »
ReplyReply

Quote from: Mulis Pictus
I have CG243W as well and I had to put the second display away as it had quite different spectrum of white compared to the new CG. When they were sitting one next to the other, the EIZO looked as having red tint and the other one a green one - very uncomfortable, at least for me. I have measured spectrum of the white of both (when calibrated to D50) and it was indeed quite different. Not sure if it is caused by different spikes of the CFL tubes or different primaries, maybe bit of both together.

So my bet would be to get EIZO Flexscan with the same panel as second display.


actually the NEC looks fine beside the Eizo and the Eizo is really perfect

thank you
Logged
Mulis Pictus
Jr. Member
**
Offline Offline

Posts: 79


WWW
« Reply #21 on: October 07, 2009, 11:28:08 AM »
ReplyReply

Quote from: erick.boileau
actually the NEC looks fine beside the Eizo and the Eizo is really perfect
That's a good news!
Logged

Pages: « 1 [2]   Top of Page
Print
Jump to:  

Ad
Ad
Ad