Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Dust deletion data  (Read 1677 times)
JeanMichel
Full Member
***
Offline Offline

Posts: 225


« on: April 19, 2010, 08:17:14 PM »
ReplyReply

Hi,

Is there a way to use the Dust Deletion Data (Canon 5D Mark II) directly in Camera Raw (CS4) ?

For the first few months of use I did not get any dust on the sensor. Did so recently and had to clean the sensor - not difficult but tedious. I will be using the camera for a few weks while away from any computers so I am planning to use the Dust Deletio Data feature just in case I end up with dust marks. I know that Canon's DPP will let me use the data, but my workflow is Camera Raw and PS so using DPP just for the dust deletion will be a bit of a chore.

Thanks for any advice.

Jean-Michel
Logged
Schewe
Sr. Member
****
Offline Offline

Posts: 5427


WWW
« Reply #1 on: April 19, 2010, 08:43:23 PM »
ReplyReply

Nope...you might ask Canon to consider documenting their format and how the data is stored...and it would be nice if there was a standard for storing such data. But alas, there are rally no standards except for EXIF and that's pretty substandard if you ask me.
Logged
JeanMichel
Full Member
***
Offline Offline

Posts: 225


« Reply #2 on: April 20, 2010, 08:55:12 AM »
ReplyReply

Thank you for your prompt reply. I was afraid that this would be the case.
And thank you for sharing your knowledge here and places such as the Camera to Print L-L tutorial and the second edition of Image Sharpening.

Jean-Michel
Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad