Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Sharpening in Canon DPP  (Read 4363 times)
Mike Sellers
Sr. Member
****
Offline Offline

Posts: 392


WWW
« on: May 08, 2010, 05:47:36 PM »
ReplyReply

I have been processing my 1dS Mark II images with a sharpening setting of 3. I just tried a setting of 10 and my results look much better. Does anyone else use a setting of 10? Is this too much sharpening at the raw stage?
Logged
BartvanderWolf
Sr. Member
****
Online Online

Posts: 3550


« Reply #1 on: May 08, 2010, 06:16:34 PM »
ReplyReply

Quote from: Mike Sellers
I have been processing my 1dS Mark II images with a sharpening setting of 3. I just tried a setting of 10 and my results look much better. Does anyone else use a setting of 10? Is this too much sharpening at the raw stage?

Hi Mike,

On the 1Ds2, in my experience, a setting of 3 is usually best (for images that are not affected by diffraction too much), unless the lens or shooting conditions dictates otherwise.

Cheers,
Bart
Logged
Chris_Brown
Sr. Member
****
Offline Offline

Posts: 782



WWW
« Reply #2 on: May 09, 2010, 08:39:01 AM »
ReplyReply

The sharpening level in the Raw tab is dependent on the content of the image and, to some degree, the setting of sharpening in the RGB tab. For example, a portrait of a baby (smooth skin) will use a lower raw sharpening setting than a landscape image. I've never used a setting of 10, though. Too harsh for my tastes, plus I prefer to apply a sharpening layer and mask out the areas I don't want affected.
Logged

~ CB
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad