Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: What's the maximum tilt normally required for landscape photography?  (Read 889 times)
Jim2
Jr. Member
**
Offline Offline

Posts: 90


WWW
« on: October 19, 2010, 11:32:56 AM »
ReplyReply

In considering an arca swiss rm3d(i) vs alpa vs perhaps a full technical camera (e.g. mline2), I'm wondering whether the 5 tilt on rm3d(i) will be sufficient for landscape photography. I have never played with tilt so I have no idea and would appreciate any help from those who are used to shooting landscape.

In what kind of scenario would more than 5 tilt be required? I have looked at the scheimpflug diagram and I would imagine that the distance between the camera and the nearest object will not affect how much tilt is required, but rather the relative angle of plane of sensor/film vs the 'ground' (assuming a flat ground here), so in this case, more tilt would only be required when photographing a valley from up above i.e. the 'ground' angle is pointing downward rather than flat.... am I thinking along the right line here? If that's the case, getting back to the original question, would 5 be enough (for a 'flat i.e. horizontal ground) or would more be required... and what about the terrain that goes downward?
Logged
Jim2
Jr. Member
**
Offline Offline

Posts: 90


WWW
« Reply #1 on: October 19, 2010, 11:34:14 AM »
ReplyReply

by 'flat' above, I meant horizontal Smiley
Logged
mtomalty
Sr. Member
****
Offline Offline

Posts: 536


WWW
« Reply #2 on: October 19, 2010, 11:47:28 AM »
ReplyReply

Jim

I have a fair bit of experience shooting landscape on most formats from 4x5 down to 35mm

When I was using a Hasselblad ArcBody, which also provided some limited movements I found i was never really needing any tilt
beyond 4-5 degrees to achieve sharp focus from a few feet to 'infinity' using the 45mm and 75mm lenses
Of course, there will be extreme situations where more will be required but i think you will be just fine with your camera choice.
FWIW, using the 24 and 45 tilt shifts on my canon bodies I'm generally finding that 2-3 degrees tilt achieve similar results for most situations where
I want extreme depth-sometimes more but not too often.

Mark
www.marktomalty.com
Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad