Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Z3100 won't feed  (Read 647 times)
DotCom Editor
Jr. Member
**
Offline Offline

Posts: 66


« on: July 22, 2011, 05:31:56 PM »
ReplyReply

I have two Z3100 printers, 24-inch and 44-inch. The 44 is working splendidly. The problem is with the 24-inch. (Both are always powered on.)

There has been no paper loaded for quite some time. The display shows the "ready for paper" message. But when I attempt to load a roll, after going through the appropriate menu selections, the paper won't "catch." The printer doesn't seem to recognize that I'm pushing paper in the feed slot. The identical operation in my 44-inch loads the paper perfectly, thus, it would appear not to be user error.

Suggestions cheerfully accepted.
Logged
mcbroomf
Sr. Member
****
Offline Offline

Posts: 389


WWW
« Reply #1 on: July 22, 2011, 08:17:38 PM »
ReplyReply

Check this out
http://www.luminous-landscape.com/forum/index.php?topic=48914.0
I had the same problem, the "flipper" was bad....
Logged

Mike Broomfield
Website
kaelaria
Sr. Member
****
Offline Offline

Posts: 2227



WWW
« Reply #2 on: July 25, 2011, 06:34:57 AM »
ReplyReply

Try turning it off and on by the switch.  Sometimes they need a reset.
Logged

Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad