Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Z3200 stopped doing automatic nozzle cleaning  (Read 617 times)
jasdown
Jr. Member
**
Offline Offline

Posts: 55


« on: December 04, 2011, 09:47:04 AM »
ReplyReply

I just noticed this weekend that my Z3200 stopped waking up from its sleep mode to do its automatic nozzle cleans. I worked in my studio for 10 hours yesterday, and not one automatic clean was done. I tried resetting the printer to factory settings in the front panel, as well as trying different timeout sleep settings, but the Z still refused to arouse from its slumber to do this periodic maintenance. Printer is out of warranty, so my appeal is to the always helpful tech support in the LuLa community. Thanks!
Logged
kaelaria
Sr. Member
****
Offline Offline

Posts: 2228



WWW
« Reply #1 on: December 06, 2011, 04:28:13 PM »
ReplyReply

I assume you tried a hard reboot by pulling power?  Make sure it's not showing any info/error such as ink low/out/out of warranty etc., that will prevent it.
Logged

Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad