Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Can i1Photo Pro 2 software show the measured spectrum  (Read 870 times)
jsch
Sr. Member
****
Offline Offline

Posts: 420


« on: October 18, 2012, 03:17:44 PM »
ReplyReply

Hi,

in the old times there was the program i1share by Gretag Macbeth. With this program it was possible to save the 30 values of the spectrum you measured with the iOne Pro. Is this possible with the new offering by X-Rite "iPhoto Pro 2" too? Thank you.

Best,
Johannes
Logged
darlingm
Sr. Member
****
Offline Offline

Posts: 291


WWW
« Reply #1 on: October 19, 2012, 01:22:54 PM »
ReplyReply

Yes, actually the i1 Photo Pro 2 can save 36 values of the measured wavelengths of spectrum measurements, from 380nm to 730nm in 10nm increments.  If you need to get those values for yourself, one of the easiest ways would probably be to save the measurements in a Custom CGATS text file - where you can tell it to write the spectrum data, in addition to any other form you need like LAB/etc.
Logged

Mike Westland Printworks
Fine Art Printing Amazing Artwork Reproduction Photography
http://www.westlandprintworks.com (734) 255-9761
Scott Martin
Sr. Member
****
Offline Offline

Posts: 1277


WWW
« Reply #2 on: October 19, 2012, 03:20:16 PM »
ReplyReply

in the old times there was the program i1share by Gretag Macbeth. With this program it was possible to save the 30 values of the spectrum you measured with the iOne Pro. Is this possible with the new offering by X-Rite "iPhoto Pro 2" too? Thank you.

The readings and visual graphics in i1Share were pretty cool weren't they? XRite doesn't offer anything like that today. IMO, the closest thing is what XRIte's ColorPort utility gives you in the measurement status area. Click on the "i" in the measurement status area and cycle though Colorimetric, Spectral and Density readings. As darlingm mentioned, you can save a CGATS file from ColorPort as well and analyze the numbers as well.
Logged

MarkM
Full Member
***
Offline Offline

Posts: 230



WWW
« Reply #3 on: October 19, 2012, 08:17:27 PM »
ReplyReply

ArgyllCMS has a utility called spotread that's pretty handy for this. It will print out the values or graph them. It comes with lots of options. It has a command line interface, which is off-putting to some, but it's easy if you get past that. More: http://www.argyllcms.com/doc/spotread.html

Logged

Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad