Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Spray Finish for Canson Plantine  (Read 604 times)
Joshua Daniels
Newbie
*
Offline Offline

Posts: 2


« on: October 22, 2012, 10:27:49 AM »
ReplyReply

So this surface is so fragile and I am quite concerned about disturbing it.
Any thoughts on a protective spray?
Logged
Atlex.com
Full Member
***
Offline Offline

Posts: 162


« Reply #1 on: October 22, 2012, 01:45:58 PM »
ReplyReply

There are a few options.  PremierArt Printshield and ClearJet Solvent spray which can work on Dye, Pigment and Solvent medias.  We carry both of these products as well as the roll on versions.

sales@atlex.com
Logged
Ken
Full Member
***
Offline Offline

Posts: 179



WWW
« Reply #2 on: October 22, 2012, 07:00:45 PM »
ReplyReply

Platine "toughens up" after about six hours, but I try to not coat it until it has sat at least 12 hours. I use PremierArt Print Shield and Hahnemühle Protective Spray.
Logged
robgo2
Sr. Member
****
Offline Offline

Posts: 325


WWW
« Reply #3 on: October 23, 2012, 08:58:39 PM »
ReplyReply

Platine is not a baryta paper, so its surface is actually more robust than those of Baryta Photographique and Gold Fibre Silk.  Still, it can scratch if one does not take care in the handling.  I have never bothered to coat my Platine prints.  How do you usually store your prints, and why do you think that they might be prone to damage?

Rob
Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad