Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Sparkly surface--Moab Entrada Rag  (Read 634 times)
robgo2
Sr. Member
****
Offline Offline

Posts: 319


WWW
« on: November 06, 2012, 05:02:29 PM »
ReplyReply

I recently got some sample sheets of Moab Entrada Rag and have made a few prints, which look reasonably good.  However, I have noticed that the surface contains some bright sparkly specks, best seen under strong light.  Does anyone know what is going on here?

Rob
Logged
colinm
Full Member
***
Offline Offline

Posts: 118


« Reply #1 on: November 06, 2012, 06:53:47 PM »
ReplyReply

Overinking. Been there, done that. Consider it a handy built-in printing tool.  Wink

If you're using an Epson, try moving one entry up the paper list in the driver.
Logged

Colin
robgo2
Sr. Member
****
Offline Offline

Posts: 319


WWW
« Reply #2 on: November 07, 2012, 01:54:21 PM »
ReplyReply

Overinking. Been there, done that. Consider it a handy built-in printing tool.  Wink

If you're using an Epson, try moving one entry up the paper list in the driver.

Interesting.  I print with an Epson 3880 using ImagePrint.

Rob
Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad