Can I use the APS and the z3200ps for profiling paper for my HP 130nr? I´m planning to do it just for a satin paper from Mitsubishi that I like a lot, which is both dye and pigment compatible.
Absolutely. Follow the guide here:http://www.luminous-landscape.com/essays/Z3100-profiling.shtml
Pretty sure this will be the same for you with the z3200 as it is with the z3100. One VERY important thing he does not tell you in the guide, before loading the printed target into the printer, you need to go to the Printer's front panel and: Setup > Printing Preferences > Print Options > set "Check Skew" to YES.
Otherwise the spectro will fail reading the chart every time because the spectro always starts from the wrong position on the target. The reason it's so important is virtually everyone who prints on sheets with the z3100 (and I assume z3200) disables "Check Skew" because loading sheets is easier with Check Skew disabled. For scanning pre-printed loaded targets, you MUST enable Check Skew. Also it may take a few times before the target sheet loads properly.