Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Can Epson 4880 print borderless on a 13" roll?  (Read 349 times)
erpman
Jr. Member
**
Offline Offline

Posts: 51


« on: April 12, 2013, 11:08:06 AM »
ReplyReply

Title says it all, am I doing it wrong or is 13" just not supported by the printer? Says that it should be on epsonīs site. Iīm going nuts here trying to figure out the right settings. I just need full bleed on both th long ends of the roll, not the start and end parts.

Input much appreciated!
Logged
smjphoto
Jr. Member
**
Offline Offline

Posts: 84


« Reply #1 on: April 14, 2013, 05:59:48 AM »
ReplyReply

I don't understand what exactly you are asking. Do you need borderless along the 13" edge or the other dimension? For example printing a 13x24.
Logged
Wayne Fox
Sr. Member
****
Offline Offline

Posts: 2810



WWW
« Reply #2 on: April 15, 2013, 12:22:05 AM »
ReplyReply

I'm not quite sure what you are asking either but I'll give it a go ...

to get a borderless print you normally will need to select borderless(auto expand).  This should result in a borderless print side to side, but will require both ends to be trimmed to the specified length to be "borderless". Trimming the print should require cutting into the printed area slightly.

If you want a borderless print produced without having to do any trimming on the ends, you will have to enable double cutting, then the printer will cut a strip of paper between each print, resulting in a full bleed print.

Logged

Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad