Ad
Ad
Ad
Pages: « 1 [2]   Bottom of Page
Print
Author Topic: Softproof in LR does not correlate well with the actual print  (Read 5018 times)
Tony Jay
Sr. Member
****
Offline Offline

Posts: 2046


« Reply #20 on: August 23, 2013, 03:45:51 PM »
ReplyReply

In Lightroom via the Printer module the printer driver settings can be accessed by clicking on the printer settings tab found on the left panel.
Everything can be set from there and the settings will be sticky.

Tony Jay
Logged
davidedric
Newbie
*
Offline Offline

Posts: 33


« Reply #21 on: September 01, 2013, 10:18:08 AM »
ReplyReply

Just note that the settings are sticky to the application.   If you also happen to have Qimage, say, then you have to set them there, too.
« Last Edit: September 01, 2013, 10:19:42 AM by davidedric » Logged
flaca
Newbie
*
Offline Offline

Posts: 5


« Reply #22 on: September 02, 2013, 04:08:55 AM »
ReplyReply

Thanks, I think either I goofed (most likely) or it's a bad profile. Trying with Ilford Galerie Premium Plus Glossy and its associated profile works just fine.
Logged
digitaldog
Sr. Member
****
Offline Offline

Posts: 8628



WWW
« Reply #23 on: September 02, 2013, 12:38:03 PM »
ReplyReply

I have a specific problem, i use a vendor provided icc profile for a matte paper, and in soft proof in LR the red colors specifically are shown as shifted towards magenta.

What is most likely cause of this magenta shift in the softproof? something wrong in the profile?

Does the vendor allow you to actually use the profile for conversion or just soft proofing? If the later, forget it, you must be assured that the profile is used with the rendering intent you select and those numbers to directly to the printer "as is".
Logged

Andrew Rodney
Author “Color Management for Photographers”
http://digitaldog.net/
Pages: « 1 [2]   Top of Page
Print
Jump to:  

Ad
Ad
Ad