Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Focus shift with aperture  (Read 695 times)
Rhossydd
Sr. Member
****
Online Online

Posts: 1987


WWW
« on: June 17, 2013, 05:39:19 AM »
ReplyReply

An interesting post about this at:-
http://www.reikan.co.uk/focalweb/index.php/2013/06/lens-focus-shift-reikan-focal/

It will be interesting to see the data produced when this feature is added to Focal and people start wider testing.
Logged
BartvanderWolf
Sr. Member
****
Offline Offline

Posts: 3853


« Reply #1 on: June 17, 2013, 07:02:42 AM »
ReplyReply

An interesting post about this at:-
http://www.reikan.co.uk/focalweb/index.php/2013/06/lens-focus-shift-reikan-focal/

It will be interesting to see the data produced when this feature is added to Focal and people start wider testing.

Hi,

Yes, interesting, but not always a big issue for many lenses and for subjects that are more 3D in nature. That doesn't mean that one shouldn't consider the effect when dialing in a micro-adjustment for a given lens/body combination. It's part of understanding the behavior of one's tools. It would be a useful addition to the Reikan software.

Another one of the variables in the test procedure is field-curvature, but I assume they tested in the image center only. Also, the color of the subject itself may cause a shift of  the focus plane, due to (Apo-)chromatic lens correction errors.

Another issue may be the color temperature and spectral composition of the light under which the AF test is conducted. In my experience, AF micro-adjustment with tungsten light, can give different results compared to daylight scenarios. That may be caused by a combination of, the lack of color correction of the phase-detect AF sensors, lack of apochromatic correction of the lenses, and field curvature.

In order to accurately test how well the resulting focus at a given aperture corresponds to the real optimal focus position, one can use a focus rail after autofocusing, and a method that gives a readout in physically defined units such as I did here with my optimal Capture sharpening evaluation after closing down the aperture to f/5.6:


When the measured amount of blur is minimized at the AF focus position, then all is fine. It also gives a sense of how far off the focus is, if it's meaningful in real life scenarios, and what is needed (to compensate) in Capture sharpening.

Cheers,
Bart
Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad