Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Is there any trick to remove Arca-Swiss glued clamps?  (Read 3922 times)
torger
Sr. Member
****
Offline Offline

Posts: 1588


« on: August 29, 2013, 12:22:35 PM »
ReplyReply

I have recently become aware that Arca-Swiss has started to glue the clamp to their heads so the bolt cannot be unscrewed to remove the clamp  Angry. This means that when you get your excellent Arca-Swiss head you still have to suffer with the poor original clamps rather than replacing it with a good one for example from Really Right Stuff, which was what "everyone" did before.

Does anyone know about any trick to remove the bolt? Has anyone done it? Like heating it with a soldering iron or something to melt the glue?

I just got a D4 and I'm considering to send it back if the clamp cannot be replaced.
« Last Edit: August 29, 2013, 12:24:16 PM by torger » Logged
NancyP
Sr. Member
****
Offline Offline

Posts: 977


« Reply #1 on: August 29, 2013, 06:28:11 PM »
ReplyReply

Please see my 8/29/13 post in the D4 geared head thread for suggestions. I haven't tried to remove my A-S original lever clamp, and I have gotten rather fond of it (on the Z1 ball head). Another option (if the head is new) is to exchange it for a D4 version with just a baseplate, and add your own favorite clamp.
Logged
ErikKaffehr
Sr. Member
****
Offline Offline

Posts: 7665


WWW
« Reply #2 on: August 29, 2013, 08:37:00 PM »
ReplyReply

Hi,

Just use a 3.5 mm hex key. The D4 head dismount using reasonable force. Ask RRS for correct plate. I made the switch and it is very easy.

Best regards
Erik



I have recently become aware that Arca-Swiss has started to glue the clamp to their heads so the bolt cannot be unscrewed to remove the clamp  Angry. This means that when you get your excellent Arca-Swiss head you still have to suffer with the poor original clamps rather than replacing it with a good one for example from Really Right Stuff, which was what "everyone" did before.

Does anyone know about any trick to remove the bolt? Has anyone done it? Like heating it with a soldering iron or something to melt the glue?

I just got a D4 and I'm considering to send it back if the clamp cannot be replaced.
Logged

torger
Sr. Member
****
Offline Offline

Posts: 1588


« Reply #3 on: August 30, 2013, 12:49:58 AM »
ReplyReply

This thread became a bit of a duplicate, sorry, so I refer back into the original D4 thread here:

http://www.luminous-landscape.com/forum/index.php?topic=64167.msg658976#msg658976
Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad