Ad
Ad
Ad
Pages: « 1 2 [3]   Bottom of Page
Print
Author Topic: Front/Back Focus Test Result  (Read 7020 times)
Fine_Art
Sr. Member
****
Offline Offline

Posts: 1157


« Reply #40 on: September 15, 2013, 01:49:25 PM »
ReplyReply

Why do you presume that, Fine_Art? This is out of my area of expertise, but my general understanding is that the Phase Detection autofocus system does not measure the light at the plane of the sensor, but diverts a portion of the light which has reached the mirror, to separate AF sensors located elsewhere.

I would imagine that the precise position, orientation and distance of those AF sensors within the camera body could affect the accuracy of autofocusing. But I'm just making a reasonable assumption based on very limited knowledge of the process.


Your post was talking about lenses so I was talking about the errors in the lens. Yes, you are right the errors in the body will impact the AF as well.

I don't think displacement of the mirror, assuming it stays at 90 degrees, would have an impact. Only a offset of the portion of the image that hits the sensor. Since you see the same thing through the viewfinder you would adjust to what you want in focus. If it goes out of 90 then there would be an error + on one side of the image and - on the other. If the Af sensors are at a different distance from the sensor plane that would make an AF error.

The body seems fairly simple compared to the complexities in the lenses. The lenses change FL so errors are magnified. The mirror just changes the direction.
Logged
Wayne Fox
Sr. Member
****
Offline Offline

Posts: 2953



WWW
« Reply #41 on: September 15, 2013, 05:22:00 PM »
ReplyReply

Which technique do you advise to do the calibration?

Do you test at two distances?
For dSLR I prefer FoCal software.  Works very well  When focus is critical I use LiveView.  Also using LiveView to calibrate AF I think would work very well.

For MFDB, I use infinity because a majority of my images will include infinity as part of the scene.  For the tech camera, I calibrate infinity using tethered mode to a computer, and I also find where I lose infinity when I stop down and focus closer ... basically I determine visually with each lens what  my max hyperfocal setting that keeps infinity sharp is from f/8 up through f/22.  With a tech camera I will use LiveView focus occasionally when something close needs to be critically sharp, but generally I just set the lens on one of these predetermined  hyperfocal points.
Logged

Pages: « 1 2 [3]   Top of Page
Print
Jump to:  

Ad
Ad
Ad