Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: Clarification request on LL CO7 video tutorial  (Read 3064 times)
ario
Full Member
***
Offline Offline

Posts: 131


« on: October 08, 2013, 03:00:25 AM »
ReplyReply

On the video n10, while illustrating the use to the "base characteristic" tool tab, in the list of the available curves a "portrait" curve was shown which I have never seen before. Is it available only for certain cameras, such as the Nikon 800 used in that demonstration?
Logged
David Grover / Phase One
Sr. Member
****
Offline Offline

Posts: 1010



WWW
« Reply #1 on: October 10, 2013, 09:31:02 AM »
ReplyReply

On the video n10, while illustrating the use to the "base characteristic" tool tab, in the list of the available curves a "portrait" curve was shown which I have never seen before. Is it available only for certain cameras, such as the Nikon 800 used in that demonstration?

Hi Ario,

The curves can depend a little on the cameras.

David

Logged

David Grover
Business Support and Development Manager, Software.
Alun
Newbie
*
Offline Offline

Posts: 41


« Reply #2 on: October 15, 2013, 03:44:56 AM »
ReplyReply

Hi,

Sorry to crash this thread but as its been answered, I also have a question on the tutorial video.

Regarding the soft-proofing segment, Michael states that he creates a Clone Variant, applies the printer icc profile to that image so that on screen there's a "before and after" view that you can make changes to align them for printing as in Lightroom. I've watched the video several times and checked and unchecked numerous options (such as "Edit All Selected Variants") and can only get C1 to apply the new icc profile to ALL the shots in the catalog and not just the Variant. As it went unchallenged in the video, I'm guessing that its me who's got settings wrong rather than this is not an option in Capture One?

Thanks in advance
Alun
Logged
wattsies
Newbie
*
Offline Offline

Posts: 17


« Reply #3 on: October 15, 2013, 09:21:34 PM »
ReplyReply

Unfortunately I think the video got it wrong, but I'd be pleased to be corrected.
Logged
FMueller
Jr. Member
**
Offline Offline

Posts: 55


« Reply #4 on: October 16, 2013, 11:35:34 PM »
ReplyReply

My observation is the same as yours. Watched the tutorial twice. Worked in the software. Softproofing applies to every image.

Unfortunately I think the video got it wrong, but I'd be pleased to be corrected.
Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad