Ad
Ad
Ad
Pages: « 1 2 [3]   Bottom of Page
Print
Author Topic: ColorMunki Photo / Printer Profiles  (Read 5349 times)
gbillett
Newbie
*
Offline Offline

Posts: 36


« Reply #40 on: December 05, 2013, 07:06:30 PM »
ReplyReply

Thanks for your views Alan.  It is also my view that having spent   on topflight camera and printing equipment,  to stint at a further 300 is ridiculous to guarantee best possible results.  I will purchase but in due course.  My experience of manufacturers profiles may change if profiles available for the ipf6400 are inferior than those for the 3800.  Printer has arrived - certainly more substantial than the the 3800 - and will put together and test next week. 

Geoff
Logged

Geoff Billett
www.geoffreybillettphotography.co.uk
www.spanishcivilwarphotography.co.uk

Author From Earth to Air   and Gateway to Nirvana
Photographs from Andalucia and the 2013 Kumbh Mela
Kevin Sholder
Newbie
*
Offline Offline

Posts: 29


« Reply #41 on: December 06, 2013, 06:35:57 AM »
ReplyReply

Geoff,

I think at some point then I may try a manufacturer's profile and then optimize that one to see the difference.  It will be an interesting test.

Thanks,
Kevin
Logged
gbillett
Newbie
*
Offline Offline

Posts: 36


« Reply #42 on: December 06, 2013, 12:51:43 PM »
ReplyReply

Hi Kevin ( Alan? - senior moment :-) )

Yes - but after Christmas.   I have a lot of printing to do early next year so will optimize then.  Thanks again.
Geoff
Logged

Geoff Billett
www.geoffreybillettphotography.co.uk
www.spanishcivilwarphotography.co.uk

Author From Earth to Air   and Gateway to Nirvana
Photographs from Andalucia and the 2013 Kumbh Mela
Kevin Sholder
Newbie
*
Offline Offline

Posts: 29


« Reply #43 on: December 15, 2013, 05:16:11 PM »
ReplyReply

gbillett,

I had some time to try and work on optimizing a factory profile, and found that the ColorMunki will not allow you to open a profile that it did not create.

When I tried to create a new one or optimize one that I had already created from the ColorMunki it was fine, but it would not open any profiles that were otherwise installed on my system.  Prints are drying from my custom profiles and the factory one now so I'll let you know what I see tomorrow.  I am testing Museo Silver Rag for this round.

Kevin
Logged
Pages: « 1 2 [3]   Top of Page
Print
Jump to:  

Ad
Ad
Ad