Ad
Ad
Ad
Pages: [1]   Bottom of Page
Print
Author Topic: printing on thin rice paper to be coated/laminated to ski?  (Read 622 times)
nairb
Full Member
***
Offline Offline

Posts: 131


« on: November 28, 2013, 05:24:50 PM »
ReplyReply

I've just had a local ski manufacturer (ie garage based) come to me asking about printing photos and graphics on rice paper to be resin coated/laminated on to a skis top sheet.

I've done some googling around and found people doing this for surf boards, but was wondering if anyone has any experience with this sort of material or know of a better process to do it.

Would there be any kind of an inkjet rice paper with a peel off backing or something like that. I did a couple prints for him on my 4880, but the paper is pretty darn thin and then the colours were way funky. I saw a suggestion online of taping the rice paper to another backing paper so it's thick/stiff enough to feed through easily.

Any suggestions?

Thanks
Logged
davidh202
Sr. Member
****
Offline Offline

Posts: 551


« Reply #1 on: November 29, 2013, 07:19:37 PM »
ReplyReply

http://dpnow.com/9378.html
Logged
mkihne
Newbie
*
Offline Offline

Posts: 35


« Reply #2 on: November 29, 2013, 08:22:50 PM »
ReplyReply

Don't know how you get around the problem with constant flexing you run into in snow skis, if that's what you are talking about. Delamination is likely your limiting issue with the other stuff doable.

I think you might be limited to a substrate with flex, like vinyl used for graphics over which you can laminate and UV protect.
« Last Edit: November 29, 2013, 08:25:55 PM by mkihne » Logged
Pages: [1]   Top of Page
Print
Jump to:  

Ad
Ad
Ad