Ad
Ad
Ad
Pages: « 1 2 [3]   Bottom of Page
Print
Author Topic: Saving takes on an SSD as long as on an HD  (Read 2854 times)
Steve Weldon
Sr. Member
****
Offline Offline

Posts: 1441



WWW
« Reply #40 on: January 07, 2014, 02:53:26 PM »
ReplyReply

You are right Steve. I apologize all.
But not for the PhotoEcosse and Kaeleare  who wrote very negative about the computerbuilder without writing what so wrong is. That is very easy!
No problem.. we all have short memories anyway..  Grin
Logged

----------------------------------------------
http://www.BangkokImages.com
kaelaria
Sr. Member
****
Offline Offline

Posts: 2184



WWW
« Reply #41 on: January 07, 2014, 06:32:53 PM »
ReplyReply

I, nor anyone ELSE without hands-on time with it, can tell you what's wrong with it.  Although I suspect that list is far longer than what's right with it.  You can be butt-hurt all you like because it's finally sinking in that through your ignorance you got suckered and your pricey new machine is performing like a POS.  That however doesn't change the cold hard facts.  I simply tell it like it is, don't like it, that's ok with me Smiley
Logged

mgalkowski
Newbie
*
Offline Offline

Posts: 3


« Reply #42 on: January 10, 2014, 05:26:04 AM »
ReplyReply

I copied the specification of my Asus X79WS which is not the cheapest.
Intel® X79 chipset :
2 x SATA 6Gb/s ports (gray), gray
4 x SATA 3Gb/s port (black), blue
Support Raid 0, 1, 5, 10
Marvell® PCIe 9128 controller :
2 x SATA 6Gb/s ports (gray), navy blue
Support Raid 0, 1

No SATA2 ports and 4 x SATA3 ports
Do you know a motherboard with more SATA6 ports?
I sent the link for downloading the file in a private message but you probably didn't see it. Please look again.

Hello Huib.
Little correction:
2 x SATA 6Gb/s ports (gray), gray = SATA3
4 x SATA 3Gb/s port (black), blue = SATA2 ( you wrote no SATA2 ports which is wrong  )

Marvell® PCIe 9128 controller :
2 x SATA 6Gb/s ports (gray), navy blue
Sata ports from this MARVELL chips are crap
This chip is connected to PCIE 2.0 1x speed which means it has only 250MBps transfer speed for write. It is less than ONE good ssd drive. If you raid them on this controller I guess it will be slower than non raid ssd. This is much much worse than SATA2 from Intel chipset.

This system builder really didn't know what was he doing.
The solution is to rearrange the drives, remove some of them from raid and plug them into different ( appropriate ) sockets.
Logged
Pages: « 1 2 [3]   Top of Page
Print
Jump to:  

Ad
Ad
Ad